ATTENTION : The following Cisco 642-446 exam questions and answers were updated in recent days with the change of new Cisco 642-446 exam, more new added questions are available at Flydumps.Please visit Flydumps and get valid Cisco 642-446 PDF and VCE exam dumps with free new version VCE player.
Exam A
QUESTION 1
Which three steps need to be performed on a third party SIP phone device when adding it to Cisco Unified
Communications Manager 6.0?
(Choose three.)
A. Select XML as the method to send the third party SIP phone its configuration file.
B. Add the MAC address of the Cisco Unified Communications Manager server to the SIP phone configuration.
C. Set the directory numbers to match the directory numbers configured in Cisco Unified Communications Manager.
D. Set the digest user ID in the SIP device to match the digest user ID in Cisco Unified Communications Manager.
E. Set the TLS user ID and password in the SIP phone to match the TLS user ID and password in Cisco Unified Communications Manager.
F. Set the proxy address in the SIP phone to match the IP address or fully qualified domain name of Cisco Unified Communications Manager.
Correct Answer: CEF Section: (none) Explanation
Explanation/Reference:
QUESTION 2
Which two gateway configuration statements are required in order to enable Cisco Unified ommunications
Manager to control a T1 PRI in an MGCP gateway?
(Choose two.)
A. mgcp
B. ccm-manager config
C. pri-group configuration on the controller
D. mgcp call-agent pointing to tftp server
E. isdn l3-backhaul ccm-manager on the serial interface
F. ccm-manager config server {TFTP ip_address}
Correct Answer: BF Section: (none) Explanation
Explanation/Reference:
QUESTION 3
If a service is currently deactivated, how can the service be reactivated from the Cisco Unified Communications Manager Serviceability Control Center page?
A. by clicking on the radio button to the left of the service on the Control Center page
B. by selecting Cisco Unified CM Serviceability > Service Activation and then clicking on the radio button to the left of the service to activate it
C. by selecting Tools > Service Activation, selecting the correct server, and clicking on the radio button to the left of the service to activate it
D. by selecting Cisco Unified CM Serviceability > Tools, clicking on the radio button to the left of the service that needs to be activated, and then returning to the Control Center to activate the service
Correct Answer: C Section: (none) Explanation
Explanation/Reference:
QUESTION 4
Which two of these media resources are available only in hardware? (Choose two.)
A. transcoding
B. audio conferencing
C. MTP
D. annunciator
E. MOH
F. voice termination
Correct Answer: AF Section: (none) Explanation
Explanation/Reference:
QUESTION 5
Which three steps are necessary in order to configure DHCP for phone support using the GUI in Cisco
Unified Communications Manager 6.0?
(Choose three.)
A. add the DHCP server IP address to the device pool
B. activate DHCP Monitor Service
C. add and configure the DHCP server
D. start the application on an external server
E. configure the DHCP subnet
F. download the DHCP server application from the plug-in page
Correct Answer: BCE Section: (none) Explanation
Explanation/Reference:
QUESTION 6
Which two of these are characteristics of multicast music on hold? (Choose two.)
A. point-to-multipoint, two-way audio stream
B. separate audio stream for each connection
C. multiple audio streams that require multiple multicast IP addresses
D. support for all codecs that are also supported by Cisco Unified Communications Manager servers
E. conservation of system resources and bandwidth
F. the requirement that there always be a dedicated MOH server
Correct Answer: CE Section: (none) Explanation
Explanation/Reference: QUESTION 7
Which three determinations are possible when using the Presence feature in a Cisco Unified
Communications network?
(Choose three.)
A. Determine if an IP phone has been unplugged if the phone is in the same Cisco Unified Communications cluster as the watcher.
B. Determine if an IP phone is on hook or off hook if the phone is outside the Cisco Unified Communications cluster of the watcher.
C. Determine if an IP phone is on hook or off hook if the phone is in the same Cisco Unified Communications cluster as the watcher.
D. Determine if a set of IP phones is on hook or off hook if if the phones are in the same Cisco Unified Communications cluster as the watcher.
E. Determine if an IP phone has been moved or the user has been changed if the phone is in the same Cisco Unified Communications cluster as the watcher.
F. Determine if an IP phone has been off hook beyond a specified period of time if the phone is in the same Cisco Unified Communications cluster as the watcher.
Correct Answer: BCD Section: (none) Explanation
Explanation/Reference:
QUESTION 8
The Ajax Corporation is designing an IP telephony network using Cisco MCS 7845 Series servers, each one capable of supporting 7500 devices. The design must meet these requirements:
be cost-effective
support up to 7500 phones
provide a minimal level of redundancy Which configuration will meet Ajax Corporation’s needs?
A.
two Cisco Unified Communications Manager servers: 1 publisher and TFTP server combined 1 primary subscriber
B.
three Cisco Unified Communications Manager servers: 1 publisher and TFTP server combined 1 primary subscriber 1 backup subscriber
C.
four Cisco Unified Communications Manager servers: 1 publisher 1 TFTP server 1 primary subscriber 1 backup subscriber
D.
five Cisco Unified Communications Manager servers: 1 publisher 1 TFTP server 1 primary subscriber 2 backup subscribers
Correct Answer: B Section: (none) Explanation
Explanation/Reference:
QUESTION 9
What is one difference between Cisco inline power and 802.3af PoE?
A. Cisco inline power should only be activated for those ports that require PoE to avoid oversubscription.
B. You must determine the total number of IP phones the switch can support with 802.3af to avoid oversubscription.
C. You must specify which set of pins the powered device is going to accept power on for 802.3af.
D. Cisco inline power provides a variable amount of power by using CDP.
Correct Answer: B Section: (none) Explanation
Explanation/Reference:
QUESTION 10
Which IP phone hardening technique will prevent call signaling and media stream tampering?
A. disable GARP
B. disable PC-to-voice VLAN access
C. use MIC firmware images signed by Cisco
D. store IP phone configuration files on the SFTP server
E. deploy authentication and encryption between IP phones and Cisco Unified Communications Manager
Correct Answer: E Section: (none) Explanation
Explanation/Reference:
QUESTION 11
Which best describes the purpose of a Cisco Unity voice-mail profile?
A. to determine whether to use the MWI on number and the MWI off number
B. to determine the number that is dialed when users press the Message button
C. to define voice-mail-related attributes
D. to assign a partition to any email-related number
Correct Answer: C Section: (none) Explanation
Explanation/Reference:
QUESTION 12
A range of Meet-Me conference numbers is reserved for manager use. Which method can be used to restrict non-managers from accessing these Meet-Me numbers without limiting their ability to initiate ad-hoc conferences?
A. Place the Meet-Me numbers in an MRGL that is only assigned to the managers’ phones.
B. Place the Meet-Me numbers in a partition that is only assigned to the CSS for the managers’ phones.
C. Place the conference bridge resource in an MRGL that is only assigned to the managers’ phones.
D. Place the conference bridge resource in a partition that is only assigned to the CSS for the managers’ phones.
Correct Answer: B Section: (none) Explanation
Explanation/Reference:
QUESTION 13
What is the minimum number of partitions that must be defined given the dial-plan rules listed below?
All employees can call local and service numbers.
Managers can call long-distance and international numbers.
Executives can call all PSTN numbers including premium numbers.
Only administrative assistants can call executives.
Incoming calls can only be routed to phones, not to trunks.
A.
3
B.
4
C.
5
D.
6
E.
7
F.
8
Correct Answer: C Section: (none) Explanation
Explanation/Reference:
QUESTION 14
The Show menu in which navigation window will allow you to determine the model, type of processors, and total memory in a Cisco Unified Communications Manager 6.0 server?
A. Cisco Unified Communications Manager Administration
B. Cisco Unified Communications Manager Serviceability
C. Disaster Recovery System
D. Platform Administration
E. Cisco Unified Operating System Administration
Correct Answer: E Section: (none) Explanation
Explanation/Reference:
QUESTION 15
Refer to the exhibit.
A call is placed from DN 5000 to DN 6999. The CSS for the call includes only the Branch 1 partition. After the translation pattern is applied, what are the called and calling numbers?
A. 6999, 5000
B. 14085556999, 5000
C. 6999, 19195555000
D. 5556999, 9195555000
E. 14085556999, 19195555000
Correct Answer: E Section: (none) Explanation
Explanation/Reference:
QUESTION 16
When using 802.3af inline power, what is the default power wattage that the Catalyst switch provides to an IP phone?
A. 0 watts
B. 4 watts
C. 7 watts
D. 15.4 watts
Correct Answer: D Section: (none) Explanation
Explanation/Reference:
The Cisco contains more than 400 practice questions for the Cisco 642-446 exams, including simulation-based questions. Also contains hands-on exercises and a customized copy of the Cisco 642-446 exams network simulation software.
