ATTENTION:With the change of the 3Com 3M0-250 exam,Flydumps has updated the 3Com 3M0-250 exam dumps with all the new added questions and answers by experts.With the 3Com 3M0-250 vce dumps training, you can pass the exam easily and quickly.
Click on the exhibit button.
Why is it important to enable Interface Tracking for VRRP routers (based on the VRRP diagram shown in the exhibit)?
A. If a link failure occurs, the path to the virtual gateway will be blocked
B. If a link failure occurs, it takes longer for the VRRP routers to reconfigure the virtual gateway path
C. If a link failure occurs, the master router can configure a new physical link to the virtual gateway
D. If a link failure occurs, a less efficient network path may be used to forward packets to the Internet or connectivity to the Internet may be lost altogether
Correct Answer: D
How would you configure the Switch 5500/7700/8000 to ensure DHCP clients can communicate with the DHCP server, regardless of which network the client and server reside on?
A. Configure the switch for UDP Helper
B. Configure the switch for DHCP Relay
C. Configure all the switches as DHCP servers
D. Configure both the DHCP master and DHCP slave
Correct Answer: B QUESTION 53
Why would you create a user-defined flow template on a Switch 8800 interface?
A. The flow template defines the actual ACL rules for the switch interface
B. The flow template defines the protocols or protocol fields that can be used in ACL rules that are not defined in the default flow template
C. The flow template must be defined on the switch interface before an ACL can be applied or enabled on the interface
D. The flow template defines what type of ACLs can be used on the switch, i.e., Layer 2, Basic Layer 3 or Advanced Layer 3 ACLs
Correct Answer: B QUESTION 54
Quality of Service (QoS) commands can be used in conjunction with ACLs on the Switch 5500/7700/8800.
Correct Answer: A QUESTION 55
Which two are general Link Aggregation (LA) configuration rules that must be followed when creating an LA group? (Choose two.)
A. A member link port can only belong to one LA group
B. Aggregated links are mutually exclusive with roving analysis and mirror ports
C. A port must be configured for resilient links before it can be configured as a member of an LA group
D. LA ports can only be configured if Link Aggregation Control Protocol (LACP) is enabled on the switches
Correct Answer: AB QUESTION 56
Which Switch 5500 command would display the status of the front panel Ethernet port #13 on switch unit #2?
A. [ 5500-EI ] display interface e 2/13
B. [ 5500-EI ] display interface e 2/0/13
C. [ 5500-EI ] display interface e 2/1/13
D. [ 5500-EI ] display interface e 13/0/2
Correct Answer: B QUESTION 57
Which best describes the result of the command 5500-EI-Ethernet1/0/1]traffic-priority inbound ip-group 3010 cos video where video is defined at priority 5 in the IEEE 8021.p priority table?
A. The Switch 5500 assigns a priority of 5 to all inbound packets
B. Ethernet port 1 on switch unit ID 1 assigns a priority of 5 to all inbound packets
C. The Switch 5500 assigns a priority of 5 to all outbound packets identified by ACL 3010
D. Ethernet port 1 on switch unit ID 1 assigns a priority of 5 to all inbound packets identified by ACL 3010
Correct Answer: D QUESTION 58
Click on the exhibit button. Why was IGMP snooping disabled on the Switch 5500 SWA VLAN Interface 1
(based on multicast commands shown in the exhibit)?
A. IGMP snooping and PIM-DM cannot be active on the same VLAN
B. IGMP snooping and PIM-DM cannot be active on the same switch
C. IGMP snooping and PIM-DM cannot be active on the same network
D. PIM-DM does all the functions of IGMP snooping and more, so IGMP snooping creates unnecessary overhead
Correct Answer: A
3Com 3M0-250 only advanced and equipped with much more features,it is also not internet dependent,once installed.It enables you to see Interconnecting Cisco Networking Devices in a simulated 3Com 3M0-250 exam environment.Working with 3Com 3M0-250 Interactive Testing Engine is like passing an actual 3Com 3M0-250 exam.